| |
 |
River float |
 |
|
|
| |
Practical advice how to use Cralusso:
If your float drifted out, its antenna is leaning towards the current. It means that leaning back is too much, thus silicon pipe on lower stem (a) should be brought nearer to the body, as far as up to the break point of stem.
If your float falls into the water during full stopping or strong retention, that means that its leaning forwards is too much.In this case the silicon pipe on the lower stem (a) should be removed from the body.Please check your antenna, if it's placed and turned at an angle of 45 degrees!
The strike should be done always dynamically and in a vertical direction!
If at the strike the float dived in the water, with the silicon pipe on the upper stem (b) should approach to the body with 5-10 mms.
If our fittings got stuck,try to float slowly against the current.
Since the floating of the lenghts and speed on the feeding stripe can be controlled by the angler, with the sensitive Cralusso we can have catching you could only wished before.
You can easily learn how the Cralusso float works and can be controlled after a few occasions.
Attention!
Protect your float from strong UV radiation and heat above +50°C as well as from mechanical damage since curving of lower and upper stems may affect adversely the usefulness of the product.
After having finished fishing remove Cralusso float and store it disassembled!
The inventor, Károly Králik race-angler wishes you much success and fruitful recreation.
|
|
| |
Králik Károly versenyhorgász
A Cralusso szabadalmazott magyar találmány.
Copyright: Králik és Társa Kkt. H-2600 Vác Temeto u. 2
PCT/HU02/00044 Made in Hungary.
Gyártja: Králik és Társa Kkt. ©
H-2600 Vác, Temető út 2. oTel.: 06-30-211-8368 |
|
|
