Beginning of the angling it is needed to adjust the Cralusso Surf:
1. Waterspeed: |
| |
There is a silicon pipe on the lower stem (a), it should be approach to the body of the float for the slower current, for stronger current it should be moved away from the body.In case of correct adjusting the antenna will stand straight or lean a little forward.
Right stremlined drawing!!! |
| 2. Adjusting before strike: |
| |
Before strike, the float can be adjusted with the silicon pipe on the upper stem (b).If at the strike the float dived in the water, with the silicon pipe should approach to the body with 5-10 mms.In case of correct adjusting the body doesn't lift out of the water with full stop, in case of vertical strike the float glides out from the water. |
| Adjusting of the joints: |
| |
Can be made conventionally.Important, that before of the adjustment pull down the slicon pipe from the upper stem, the way we can avoidthe bend of the upper stem.
In case of middle,average current the Cralusso Surf can be stopped compared to the bank at an angle of 30-60 degrees. |
| Feeding: |
| |
Before starting with feeding it's recommended to float Cralusso to the desired place, and wait, till it stop the first.Put down the rod, mark the string above the reel and feed over the float!Thus you can always know when fitting is on feeding. |
